Справочник Пользователя для Mitsubishi Electronics 60/60S

6.  Data In/Out 

6.4  PROGRAM COPY 

 

 

 

I-257 

 
 

A machining program selected among work programs registered in memory can be copied as another 
program having a different program number. The source program remains intact. 

 

Set 1 in # (   ) for the copy command. Set the program number of the copy source program and the program 
number of new program.

 

 

Press the 

 

 

INPUT 

 key. 

(Example) 
To copy program O1000 into O2000 

# ( 1 ) 

O ( 1 0 0 0 ) 

→ O ( 2 0 0 0 ) 

 
 
 # (  1 )O (  1000)

→O(  2000) 

 
  COPY 

EXECUTION 

 # (  1 ) O(  1000)

→O(  2000) 

 
  COPY 

COMPLETE 

  # (        ) O(            )

→O(            ) 

1)  A copy is started and the 

message "COPY EXECUTION" is 
displayed in the message field. It 
may be terminated in a moment 
(when there is less copy data). 

2)  When the copy is complete, the 

message "COPY COMPLETE" is 
displayed in the message field. 

 

1)  When using the 2-part system, the machining program copy operation can be switched with the 

parameters. 

0, 2, 4, 6 

- 

Of the machining programs registered in the memory common for the systems, 
the designated machining program is copied to the memory common for the 
systems with a different machining program number. 

1, 3, 5, 7 

OFF 

Of the machining programs registered in the memory for the selected systems, 
the designated machining program is copied to the memory for the selected 
system as a different machining program number. 

 

ON 

Of all the machining programs registered in the memory for each system, the 
designated machining program is copied to the memory for each system with a 
different machining program number. 

2)  When using the 2-part system and the same number batch generation for all system programs is 

valid, an error (E64) will occur if the copy destination program is found in any of the systems.