Справочник Пользователя для Mitsubishi Electronics 60/60S

Appendix 4. Registering/Editing the Fixed Cycle Program

4.1  Fixed cycle Operation Parameters 

 

 

 

IV-4 

 
 

The subprogram for the fixed cycle can be input, output and edited. 

 
 

 

 

 

 

 

  

 

 

Do not change the fixed cycle program without prior approval from the machine maker. 

 
 

 
 

To input/output or edit the data of each fixed cycle subprogram, use the IN/OUT and EDIT screens in the 
same way as when creating usual user-created work programs. In this case, the parameters must have 
been set. Set "1" in parameter "#1166 fixpro" on the BASE SPEC. PARAM screen. If this parameter is valid, 
the IN/OUT and EDIT screens are usable only for operating a fixed cycle control subprogram. During this 
period, PROGRAM FILE displays only fixed cycle programs. Thus, after fixed cycle program operation, 
return parameter to "0". 

 (Note)  Parameter fixpro will be set to 0 when the power is turned OFF. 
 
 

 
 

Input the fixed cycle program from the DATA INPUT screen. Before input, check that fixed cycle operation 
parameter "#1166 fixpro" is valid. 

 

The operating procedure is the same as a user machining program. It is desirable that the data can be input 
consecutively. 

 

After the data is registered, check proper registration on the PROGRAM FILE and EDIT screen. 

 
 

 
 

Output the fixed cycle program on the DATA OUTPUT screen. Before output, check that fixed cycle 
operation parameter "#1166 fixpro" is valid. 

 

The operating procedure is the same as a user machining program. The registered fixed cycle programs 
can be output one by one or at a time. 

 

If the programs have been output at a time, they can be input consecutively by one operation. 

 

After the data is output, be sure to collate it with the data on tape. At this time, make sure that there are no 
data output mistakes (punch mistakes, etc.). 

 
 

 
 

Erase the fixed cycle program on the PROGRAM ERASE screen. Before erasing, check that fixed cycle 
operation parameter "#1166 fixpro" is valid. 

 

The operating procedure is the same as a user machining program, except set 4 in # (   ) to designate the 
fixed C program.