Справочник Пользователя для Mitsubishi Electronics 60/60S

2.  Monitor 

2.3  COMMAND 

 

 

 

I-46

 

 

Display item 

Explanation 

The rotation angle for the program coordinate rotation command is 
displayed. 

The scaling magnification is displayed. 

G68: R= 

(M system) 

G51: P= 

(M system) 

G05: P10000  (M system) 

The high-speed machining mode and high-speed high-accuracy 
mode are displayed. 

High-speed machining mode 3 

(G05  : P3) 

High-speed high-accuracy control II  (G05  : P10000) 
SSS control valid 

(G05  : P10000S) 

High-speed high-accuracy control I  (G05.1 : Q1) 
Spline interpolation 

(G05.1 : Q2) 

Mode OFF 

(G05  : P0) 

Tx: –12.345 

(L system) 

Tz: 12.345  (L 

system) 

Tc: 10.000  (L 

system) 

The total of the X axis, Z axis and additional axis' tool length and 
wear compensation amounts for the tool being used is displayed. 

Tg: 12 

(L 

system) 

Tw: 12 

(L 

system) 

The tool length offset No. is displayed. 
The wear compensation No. is displayed. 

v    

(L 

system) 

FA  24000.00 
 
FM 1200.00 
FS 0.0000 
 
FE  

0.0000    (L  system) 

 
S 12345 
 
T 1234 
 
M  12345678  10  35  40 
 
B 1234 

The constant surface speed spindle rotation speed is displayed. 
The program command asynchronous feedrate modal value 
currently being executed is displayed. (mm/min) 
The manual feedrate is displayed. (mm/min) 
The program command synchronous feedrate modal value 
currently being executed is displayed. (mm/rev)  
The thread lead command synchronous feedrate modal value 
currently being executed is displayed. (mm/rev) 
The modal value of the current program command S being 
executed is displayed. 
The modal value of the current program command T being 
executed is displayed. 
A maximum of four modal values of the current program command 
M being executed are displayed. 
The second miscellaneous function modal value of the current 
program command being executed is displayed. 

N300  G1X-100.234~ 

The current program block being executed is displayed.