Справочник Пользователя для Mitsubishi Electronics 60/60S

 

 

 

 

1. Items related to product and manual 

 

 

For items described as "Restrictions" or "Usable State" in this manual, the instruction

manual issued by the machine maker takes precedence over this manual.

 

 

 

Items not described in this manual must be interpreted as "not possible".

 

 

 

This manual is written on the assumption that all option functions are added. Confirm 

with the specifications issued by the machine maker before starting use.

 

 

 

Refer to the Instruction Manual issued by each machine maker for details on each 

machine tool.

 

 

 

Some screens and functions may differ depending on the NC system (or its version), 

and some functions may not be possible. Please confirm the specifications before 
use. 

 

 

Ground the signal cables to ensure stable system operation. Also ground the NC unit 

main frame, power distribution panel and machine to one point, so they all have the 
same potential.   

 

 

If the control unit's rotary switch is set to "7", all data in the NC will be erased and the 

system will not start up.

 

3. Items related to preparation before use 

 

 

Always set the stored stroke limit. Failure to set this could result in collision with the 

machine end. 

 

 

Always turn the power OFF before connecting/disconnecting the I/O device cable. 

Failure to do so could damage the I/O device and NC unit. 

 

4. Items related to screen operation 

 

 

If the tool offset and workpiece coordinate system offset are changed during automatic 

operation (including during single block stop), they are validated from the command of 
the next block or blocks onwards. 

 

 

 

When forcibly setting (forcibly outputting) data on the I/F diagnosis screen during 

machine operation, pay careful attention to the sequence operation.   

 

 

All of the various data in the NC memory is erased when formatting. Be sure to use 

the transfer function to transfer all necessary data to another storage device before 
formatting.  

 

  Even if the tool compensation amount write command, parameter write command or 

variable data write command is executed with graphic check, the data will be actually 
written in, and the original data will be overwritten. 

 

 

To prevent influence from data omission and data transformation in the communication 

circuit, always verify the data after inputting and outputting machining programs.

 

 

Do not change setup parameters without prior approval from the machine maker. 

5. Items related to programming 

 

 

Because of key chattering, etc., during editing, "NO NOS. FOLLOWING G" commands 
become a "G00" operation during running.

 

 

 

" ; " "EOB" and " % " "EOR" are explanatory notations. The actual codes are "Line 
feed" and "%" for ISO, and "End of Block" and "End of Record" for EIA.

 

 

 

Do not change the fixed cycle program without prior approval from the machine maker.

 

  (Continued on next page)