Справочник Пользователя для Mitsubishi Electronics SDP-ECO 1630 III

Chapter 4   Operation

The processing chemicals are applied to the plate while it is being transferred
in the SDP-Eco 1630 III's built-in processor section.  The processor section
also includes a final rinsing process which cleans the developed plates and
thus reduces paper media waste (from processing chemical stains) at the start
of printing.

You must thoroughly read "1.3 Handling processing chemicals".

•

1) Fasten a replenishment cap on the replenisher bottle which contains the

processing chemical and set it in the tank.

Be sure to set the bottle in the appropriate tank since the SLM-EAC
and SLM-EST cause different (opposing) effects.

•

As the processing chemical decreases, the liquid level in the tank goes down
and finally the "Empty EST" or "Empty EAC" message appears on the display
(accompanied by a buzzer sound).  Replenish the processing chemical
following the procedure below.
Replenish the processing chemical and replace the processing bottle
following the procedure below.
1) Press the 

key to turn off the buzzer.

2) Open the front door.
3) Add processing chemical from the container (10 liters) to the replenisher

bottle.

4) Put the cap back on the replenisher bottle and set it in the tank.

Caution

- 31 -

Rinse water
replenisher
bottle

Washing tank

Waste
water hose

SLM-EST
drainage
hose

SLM-EST
replenisher
bottle

Processor rack

SLM-EST
processing
chemical tank

SLM-EAC
replenisher
bottle

SLM-EAC
processing
chemical tank

SLM-EAC
drainage
hose

Cap

Waste chemical vat

Waste chemical tank