Справочник Пользователя для Intel IXD1110

13

Document Number: 250807
Revision Number: 003
Revision Date:  June 27, 2003

The IXD1110 demo board uses the Embedded Planet* RPX Classic LF (CLLF_BW31), a single-

board computer that uses the Motorola* MPC860 CPU. This card attaches to the underside of the 

board and is used to interface with the IXF1110 CPU interface. 

 

provides a top-level view 

of the CPU daughter card.

The IXF1110 software requires the proper connections to the daughter card as follows:

Note: For full operation of the IXF1110 software, RJ-45 #1 and #2 (see 

) must be connected to a 

PC.

•

RJ-45 #1 (10 Mbps Ethernet): Requires the following connection (this connection gives access 

to the GUI):

— CAT5-UTP cable (connected to the CPU daughter card)

— Network port on a PC (connected to the CAT5-UTP cable), installed with IXF1110 

software

•

RJ-45 #2 (Serial): Requires a connection that gives access to the HyperTerminal interface of 
the IXF1010 software (refer to 

 for 

complete setup information).

•

 provides the DB-9–to–RJ-45 connector pinout for connection to a PC COM port. 

Only three pins are used for the DB-9–to–RJ-45 connector.

RJ-45 #1 10Mbps

Ethernet Connection

RJ-45 #2 Serial

Connection

Not Used

IP Address located on

the side of the connector

4

5

5

3

6

2