Справочник Пользователя для Intel IXD1110

Скачать
Страница из 40
IXD1110 Demo Board
16
Development Kit Manual
Document Number: 250807
Revision Number: 003
Revision Date:  June 27, 2003
5.2
Installing the IXF1110 Software
For proper installation of the IXF1110 software, follow these steps:
1. Verify that the CAT5-UTP cable is connected between the PC and the IXF1110 CPU daughter 
card. This allows access to the GUI interface. Refer to 
 for detailed installation instructions.
2. (Optional) The following connection is required to access the HyperTerminal interface:
— CAT5-UTP cable (connected to a CPU daughter card)
— DB-9–to–RJ-45 connector (connected to a CAT5-UTP cable)
— DB-9–to–RJ-45 connector (connected to a COM port on a PC installed with IXF1110 
software)
For more information, refer to 
 for detailed 
instructions.
3. Insert the CD into the PC.
4. If your system supports Autorun, follow the on-screen instructions.
5. If your system does not support Autorun, select Run... from the Start menu. The Run dialog 
opens.
6. Select setup.exe from the CD in the Open: window (click Browse... to find setup.exe if not 
already in the window).
7. Click OK.
8. Follow the on-screen instructions.
9. Locate the IXD1110 demo board IP address that is located on the CPU daughter card. The IP 
address is required each time the GUI is opened.
10. Start the IXF1110 software GUI by double clicking the desktop icon.
Note: The IXF1110 software includes online documentation that describes how to run the GUI and 
HyperTerminal interfaces. Refer to the quick-start section of the IXF1110 Demonstration Software 
Help File for additional instructions on use of these interfaces.
5.3
Changing the IP Address of the CPU Daughter Card 
(Optional)
The CPU daughter card comes with a default IP address, which is listed on a sticker attached to the 
daughter card. The GUI uses this IP address to locate the IXD1110 demo board. The IP address 
may need to be changed depending on the PC or network to which the board is attached. Use the 
following procedure to permanently change the IP Address of the CPU daughter card:
1. Ensure the IXD1110 demo board has been set up correctly (see 
).
2. Open the HyperTerminal on the PC to which the CPU daughter card serial port is attached, and 
configure the relevant COM port with the following settings:
Speed: 9600 Baud
Databits: 8