Справочник Пользователя для Lucent Technologies R5SI
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-155
BRI-BD/LGATE-BD (ISDN-BRI Line Circuit Pack)
10
Control Channel Loop Around Test (#52)
Refer to the repair procedure described in the "XXX-BD (Common Port Circuit
Pack)" Maintenance documentation as Control Channel Loop Around Test (#52).
Pack)" Maintenance documentation as Control Channel Loop Around Test (#52).
SAKI Sanity Test (#53)
Refer to the repair procedure described in the "XXX-BD (Common Port Circuit
Pack)" Maintenance documentation as SAKI Sanity Test (#53).
Pack)" Maintenance documentation as SAKI Sanity Test (#53).
LANBIC Receive Parity Error Counter Test (#595)
This test is destructive
.
The test reads and clears the LANBIC Receive Parity Error Counter on the circuit
pack. This counter is incremented by the circuit pack when it detects a parity
error in data received from the Packet Bus.
pack. This counter is incremented by the circuit pack when it detects a parity
error in data received from the Packet Bus.
These errors may be indicative of a circuit pack problem, Packet Bus problem, or
a problem with another circuit pack on the bus. This test is useful for verifying the
repair of the problem.
a problem with another circuit pack on the bus. This test is useful for verifying the
repair of the problem.
Table 10-52.
TEST #595 LANBIC Receive Parity Error
Counter Test
Error
Code
Test
Result
Description/ Recommendation
2000
ABORT
Response to the test was not received from the circuit
pack within the allowable time period.
pack within the allowable time period.
1. If the test aborts repeatedly a maximum of five times,
reset the circuit pack via the
busyout board PCSS
and
reset board PCSS
commands.
2. If the test aborts again, replace the circuit pack.
2100
ABORT
Could not allocate the necessary system resources to
run this test.
run this test.
2012
ABORT
Internal System Error.
1. Retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to fail, escalate the problem.
Continued on next page