Справочник Пользователя для Lucent Technologies R5SI
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-608
test led
8
Feature Interactions
The maintenance of a particular component on a link will sometimes interfere with
the maintenance of the link itself. Maintenance can put a link component in a
busy state causing link set-up to fail. Frequent attempts at re-setup of a link may
delay the recovery of a faulty component, due to the maintenance test of a
component only taking place when the component is idle. Therefore, the
technician needs to be able to disable the attempted re-setup of a link. The
busyout command is used to do this, and will cause the link to be torn down. If
the link is already down, the busyout command will stop periodic re-setup trys on
the link.
the maintenance of the link itself. Maintenance can put a link component in a
busy state causing link set-up to fail. Frequent attempts at re-setup of a link may
delay the recovery of a faulty component, due to the maintenance test of a
component only taking place when the component is idle. Therefore, the
technician needs to be able to disable the attempted re-setup of a link. The
busyout command is used to do this, and will cause the link to be torn down. If
the link is already down, the busyout command will stop periodic re-setup trys on
the link.
test led
This command will perform a test on all the LEDs in a specified cabinet. The test
consists of turning all the LEDs on all circuit packs on and then off.
consists of turning all the LEDs on all circuit packs on and then off.
Synopsis
test led
[ all | cabinet number ] [ short | long ] repeat number
Permissions
The following default logins may execute this command: system technician,
inads, init.
inads, init.
Examples
test led
test led all r 2
test led cabinet 1
test led c 1
test led 1 long
test led all r 2
test led cabinet 1
test led c 1
test led 1 long
Description
The test led command will validate that the specified cabinet exists. Once the
range of circuit packs is determined, the test LED command will turn on all LEDs
on the circuit packs contained in each carrier until all affected carriers are lit.
Once all the LEDs are on there will be a 2 second pause and then all the LEDs
will be turned off in the same order as they were lit. Once all of the repeat cycles
are completed, all affected LEDs will be restored to the current status.
range of circuit packs is determined, the test LED command will turn on all LEDs
on the circuit packs contained in each carrier until all affected carriers are lit.
Once all the LEDs are on there will be a 2 second pause and then all the LEDs
will be turned off in the same order as they were lit. Once all of the repeat cycles
are completed, all affected LEDs will be restored to the current status.
On a duplex PPN, only the long option will test the leds in the standby SPE. When
executing the test led long command, the standby Processor, Memory and
Packet Control circuit pack LEDs can take up to 20 seconds to light.
executing the test led long command, the standby Processor, Memory and
Packet Control circuit pack LEDs can take up to 20 seconds to light.