Справочник Пользователя для Lucent Technologies R5SI
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-24
ADX8D-PT (AUDIX Digital Port)
10
NO-OP Tests
The maintenance strategy for DEFINITY AUDIX emulates the one for DIG-LINE.
The tests listed below apply only to DIG-LINE and not to DEFINITY AUDIX. These
are referred to as
The tests listed below apply only to DIG-LINE and not to DEFINITY AUDIX. These
are referred to as
NO-OP
tests, and they always return PASS.
■
Electronic Power Feed Test (#11)
■
Station Lamp Updates Test (#16)
■
Station (Digital) Audits Test (#17)
NPE Crosstalk Test (#9)
This test verifies that this port’s NPE channel talks on the selected time slot and
that it never crosses over to time slots reserved for other connections. If the NPE
is not working correctly, one-way and noisy connections may be observed. This
test is part of a port’s Long Test Sequence, and it takes about 20 to 30 seconds
to complete.
that it never crosses over to time slots reserved for other connections. If the NPE
is not working correctly, one-way and noisy connections may be observed. This
test is part of a port’s Long Test Sequence, and it takes about 20 to 30 seconds
to complete.
Crosstalk testing is performed on both the primary information channel (voice)
and on the secondary information channel (data) associated with each DEFINITY
AUDIX port. If this test fails on either channel, the voice port is taken
out-of-service.
and on the secondary information channel (data) associated with each DEFINITY
AUDIX port. If this test fails on either channel, the voice port is taken
out-of-service.
Table 10-10.
TEST #9 NPE Crosstalk Test
Error
Code
Code
Test
Result
Description/Recommendation
1
ABORT
During testing of the primary information channel, system resources may not
have been available. Also, the port may have been busy during the test.
have been available. Also, the port may have been busy during the test.
1. Check the port status. Use the
display port PCSSpp
command to
determine the voice port extension of the port. Use the
status station
command to determine the service state of the port. If the service state
indicates that the port is in use, you must wait until the port is idle. When
the port is idle, try (a).
indicates that the port is in use, you must wait until the port is idle. When
the port is idle, try (a).
2
ABORT
System resources may not have been available, or the port may have been
busy during the test. Try (a).
busy during the test. Try (a).
1000
ABORT
System resources required to run this test are not available. The port may be
in use. Use the
in use. Use the
display port PCSSpp
command to determine the voice port
extension of the port. Use the
status station
command to determine the
service state of the port. If the service state indicates that the port is in use,
you must wait until the port is idle before retesting. Try (a).
you must wait until the port is idle before retesting. Try (a).
1001
ABORT
System resources required to run this test are not available. Try (a).
Continued on next page