Справочник Пользователя для Barco 26-0503000-00

MatrixPRO Operating Procedures

 

The following operating procedures are covered in this section:

„

Use the following steps to perform a take:  

1.  In the Output Selection Section, select the output channel (destination) to which 

you want to route an input.  Please note:

If an input is already associated with that output on a completed route, 
the input button lights steady.  

If an input is already associated with that output on a pending route, the 
input button blinks.  

If there is no input associated with the output, the output is “blanked” and 
no input buttons will light. 

2.  In the Input Selection Section, select a new input source.  The selected 

(pending) input button blinks.

3.  Press TAKE.  The selected input button lights steadily, and the Status Menu 

updates accordingly.  

4.  Repeat from step 1 to perform another take.

Please note the following important points:

To cancel a route before pressing TAKE, press ESC, or press the blinking input 
button to “de-select” it.  The previous route remains in effect.

A “pending” route remains pending — even if you switch to a different output — 
until TAKE or ESC is pressed.  This rule applies to channel routes, test pattern 
routes, and RGB Mute routes.

S

If you pend a route to output 1 (e.g., input 5 to output 1), then you switch to 
output 2, and then you switch back to output 1 — the selected route is still 
pending (and input 5 will still be blinking).