Справочник Пользователя для Extron electronic 300S

 

Installing the Cables

Three half-moon cutouts in each set of cable pass-through (split) AAPs loosely channel 
three cables in the Cable Cubby. Each channel is padded with a split grommet to prevent 
cable wear. Each channel and each associated split grommet is a different size  
(see figure 

9).

Large

Medium

Small

Large

Medium

Small

Large

Medium

Small

Large

0.625" (1.59 cm)

0.453" (1.15 cm)

Medium

0.562"  (1.43 cm)

0.390" (0.99 cm)

Small

0.5" (1.27 cm)

0.312" (0.79 cm)

A typical installation consists of a VGA cable, an audio cable, and a network cable. In a 
typical installation, the VGA cable runs in the largest channel, the network cable runs in the 
middle (medium) channel, and the audio cable runs in the smaller channel. In a  
non-standard installation, match the diameter of the cable to the size of the channel as best 
you can.
Install cables in the channels as follows:

Remove a segment of a set of split AAPs by unscrewing the nuts on the underside of 
the bracket that fastens the plate to the shelf bracket (see 

7).

Rest the cables in the half-moon cutouts of the split AAP segment still mounted on the 
shelf brackets. Place the cables so that the connectors protrude from the front of the 
split AAP segment.

Insert the screws of the split AAP segment that you removed in step 

1 through the holes 

in the shelf bracket. Ensure that the cables are free in the channels that the two split 
AAP segments form without being pinched where the two segments meet.

Secure the split AAP segment to the shelf brackets with the provided captive washers 
and #4-40 nuts.

Slip the appropriate size split grommet over each 
cable with the flange of the grommet toward the 
connector that will be accessible inside the Cable 
Cubby. Snap the grommets into the channels.

If applicable, snap the included hole plugs into unused 
channels in place of the split grommets.