Справочник Пользователя для Extron electronic 300S

 

Preparing the Table with a Hole Saw (Cable Cubby 300C Only)

Prepare the table with a hole saw as follows:

On the tabletop or other installation surface, mark the 6 inch circle, then find and mark 
the center of the circle.

CAUTION:  Risk of injury to the eyes. Wear safety glasses when operating the 

drill. Failure to comply can result in eye injury.

Using a portable drill with a 6-inch (or 152 mm) hole saw, carefully cut the opening in 
the table surface at the desired location (see figure 

6). Extron is not responsible for an 

improperly positioned Cable Cubby.

ATTENTION:  Potential damage to property. Use a portable drill with sufficient 

power to handle the 6-inch hole saw. Exercise caution when handling the drill and 
hole saw. Take care to protect the mounting surface from damage.

 

Installing the Cables and AAPs

Each Cable Cubby model ships with one or two moveable AAP shelf assemblies.

AAP Shelf Brackets

Each shipped AAP shelf assembly consists of a set of shelf brackets and a number of cable 
pass-through (split) AAPs. Depending on the Cable Cubby model, each set of shelf brackets 
supports either two-, three-, or four-space AAPs (see figure 

7).

Four-Space Shelf Bracket

and Split AAPs

Three-Space Shelf Bracket

and Split AAPs

Two-Space Shelf Bracket

and Split AAPs