Справочник Пользователя для Extron electronic 300S

Installation

This section covers the following topics:

•

•

•

•

•

Installation Overview

Install and set up the Cable Cubby enclosures as follows:

If you plan to use a mounting template that has not been prepared, prepare the 
template (see “

” below).

Cut a hole in the surface where the enclosure will be installed (see “

” on the next page).

Run all cables necessary to support the AC connector, the cables stored in the cubby, 
and all planned AAP connectors. Leave enough slack in the cables to connect or route 
them before the cubby is installed in the table.

If applicable, install the power module. If your location requires electrical conduit, install 
an Extron flexible conduit kit. Refer to the Flexible Conduit Kit Installation Guide, Extron 
part number 

68-734-01.

Install all desired cables into the cable pass-through (split) AAPs and install the AAPs 
into the Cable Cubby (see “

7).

If applicable, connect cables to the rear connectors on the passive AAPs and install the 
AAPs in the cubby (see “

” on page 

10).

10).

Peel the protective film from the top surface.

Connect the Cable Cubby power cord.

Preparing the Routing Template

Extron offers metal templates for each Cable Cubby model; see “

19 for part numbers. Extron recommends using this template as a 

guide to cut the hole in the table where the cubby will be installed.

NOTE:

The metal routing template is reusable. Do not discard this template when the 

installation is complete. Save it for installing Cable Cubby models of the same size.

Cut 1/2 inch x 4 inch strips of soft, finished lumber to a length that is long enough to 
span the distance between the desired installation location on the mounting surface and 
the edges of the mounting surface (see 

).