Справочник Пользователя для Extron electronic 300S

 

These strips raise the routing template above the mounting surface to provide room 
for the collar of the router, protect the mounting surface, and extend the reach of the 
routing template so that it can be clamped to the edge of the surface. 

HSA 200

USER 

A

C

C

E

S

S

HSA 20

0

CABLE C

UBBY 300

CABLE CU

BBY 300

USER 

A

C

C

E

S

S

1/2” x 4” Soft, Finished

Lumber

4 Screws Min.

Routing Area

Width of Mounting Surface

Using four or more short wood screws, secure the mounting template to the lumber 
strips.

ATTENTION:  Potential damage to property. Do not allow the wood screws to 

protrude through the bottom of the wooden strips. Protruding screws will scratch 
the table when the template is used.

Preparing the Table

The preferred and recommended method for preparing the table for square Cable Cubby 
models is to use the appropriate Extron routing template and a router.
For the Cable Cubby 300C, you may use the routing template and a router or use a 6-inch 
hole saw.

ATTENTION:  Potential damage to property. The opening in the table for the 

Cable Cubby should be cut only by licensed and bonded craftspeople. Exercise care to 
prevent scarring or damaging the furniture.

ATTENTION:  Potential damage to property. The surfaces of the Cable Cubby 

enclosure have screws and other protruding hardware that could damage fine furniture. 
Do not rest the enclosure on unprotected furniture.

Alternatively, for any model, you can use a paper cut-out template (see “

20) and a sabre saw or keyhole saw. However, this method is not 

recommended.