Справочник Пользователя для Acer 1000
82
Chapter 4
Check the Battery Pack
Follow the procedures below to check the battery pack.
From software, this helps to identify the problem is on recharging or discharging.
1.
Check the Power Management in Control Panel.
2.
Then confirm that the parameters shown in the screen for Current Power Source and Total Battery
Power Remaining are correct.
Power Remaining are correct.
3.
Repeat the step 1 and step 2 for both battery and adaptor.
From hardware, this helps to identify whether you should replace the battery pack or not.
1.
Power off the system.
2.
Remove the battery pack and measure the voltage between terminals one (+) and seven (-). There are
seven terminals totally. See the illustration below.
seven terminals totally. See the illustration below.
3.
If the voltage is still less than 7.5V after recharging, replace the battery.
If the battery status indicator does not light up, remove the battery pack. After the battery pack
returns to room temperature, reinstall it to the system.
returns to room temperature, reinstall it to the system.
If the charge indicator does not light up, replace the battery pack. If the charge indicator still
does not light up, replace the AC / DC charger board.
does not light up, replace the AC / DC charger board.
Touchpad Check
If the touchpad does not work, follow the procedures one at a time to correct the problem. Do
not replace a non-defective FRU.
not replace a non-defective FRU.
1.
Reconnect the touchpad cables.
2.
Replace the touchpad.
3.
Replace the system board.