Справочник Пользователя для Acer 1000
84
Chapter 4
Power-On Self-Test (POST) Error Message
The POST error message index lists the error message and their possible causes.
NOTE:
Perform the FRU replacement or actions in the sequence shown in Error Message List, if the FRU
replacement does not solve the problem, put the original part back in the computer. Do not replace a
non-defective FRU.
non-defective FRU.
The error messages are listed in the coming pages to indicate the BIOS signals on the screen and
the error symptoms classified by functions. If the symptom is not included on the list, please refer
to Undetermined Problems.
the error symptoms classified by functions. If the symptom is not included on the list, please refer
to Undetermined Problems.
NOTE:
Most of the error messages occur during POST. Some of them show information about a
hardware device, for example, the size of memory installed. Others may indicate problems with a
device, such as the way it has been configured.
device, such as the way it has been configured.
NOTE:
If the system fails after you make changes in the BIOS Setup Utility menus, please reset the
computer. Enter Setup and install Setup defaults to correct the errors.
Index of Error Messages
Error Code List
Error Message List
Error Code
Error Message
006
Equipment Configuration Error Causes:
•
CPU BIOS Update Code Mismatch
•
IDE Primary Channel Master Drive Error
The causes will be shown before Equipment Configuration Error.
010
Memory Error at xxxx:xxxx:xxxxh (R: xxxxh, W: xxxxh)
070
Real Time Clock Error
071
CMOS Battery Bad
072
CMOS Checksum Error
110
System disabled.
Incorrect password is specified.
Incorrect password is specified.
No error code
Battery critical low: In this situation BIOS will issue four short beeps
then shut down system, no message will be shown.
then shut down system, no message will be shown.
No error code
Thermal critical high: In this situation BIOS will shut down the
system, no message will be shown.
system, no message will be shown.
Error Message
FRU/Action in Sequence
Failure Fixed Disk
Reconnect hard disk drive connector.
Run Load Default Settings in BIOS Setup Utility.
Hard disk drive
System board
Run Load Default Settings in BIOS Setup Utility.
Hard disk drive
System board
Stuck Key
see Keyboard or Auxiliary Input Device Check.
Keyboard error
see Keyboard or Auxiliary Input Device Check.
Keyboard Controller Failed
see Keyboard or Auxiliary Input Device Check.
Keyboard locked - Unlock key
switch
switch
Unlock external keyboard
Monitor type does not match
CMOS - Run Setup
CMOS - Run Setup
Run Load Default Settings in BIOS Setup Utility.