Справочник Пользователя для National Instruments SCC-CO20

© National Instruments Corporation

❑

Tools

–

1/8 in. flathead screwdriver

–

Numbers 1 and 2 Phillips screwdrivers

–

Wire insulation stripper

Software scaling of measurements is not supported on the Macintosh operating 

system. Refer to the 

 section.

You can download NI documents from 

ni.com/manuals

. To download 

the latest version of NI-DAQmx, click Download Software at

ni.com

.

For general SCC module installation and signal connection information, and 

information about the SC-2345/2350 carrier, refer to the SCC Quick Start Guide, available 
for download at 

ni.com/manuals

.

Refer to the Read Me First: Safety and Radio-Frequency Interference document 

before removing equipment covers or connecting/disconnecting any signal wires.

Plug the SCC-CO20 into either SC-2345/2350 analog output socket 
J(X

+17), where X is 0 or 1. The SC-2345/2350 routes the voltage output of 

E/M Series DAQ device analog output channel AO (X) to the SCC-CO20.

The signal names have changed. Refer to 

ni.com/info

 and enter 

rdtntg

 

to confirm the signal names.

The screw terminals are labeled by pin number <1..3>. Pin 1 is the ground, 
pin 2 is the current sink, and pin 3 is the isolated loop supply. Figure 1 
shows how the ground, sink, and supply connect to the E/M Series DAQ 
device.