Справочник Пользователя для National Instruments NI PXIe-1065

If your power outlet does not have an appropriate ground connection, you 
must connect the premise safety ground to the chassis grounding screw 
located on the rear panel. Refer to Figure 1-2, 

, to locate the chassis grounding screw. To connect 

the safety ground, complete the following steps:

1.

Connect a 16 AWG (1.3 mm) wire to the chassis grounding screw 
using a grounding lug. The wire must have green insulation with a 
yellow stripe or must be noninsulated (bare).

2.

Attach the opposite end of the wire to permanent earth ground using 
toothed washers or a toothed lug.

Do not install modules prior to performing the following power-on test.

To completely remove power, you must disconnect the AC power cable.

Attach input power through the rear AC inlet using the appropriate 
AC power cable supplied. Refer to Figure 1-2, 

, to locate the AC inlet.

The Inhibit Mode switch allows you to power on the chassis or place it in 
standby mode. Set the Inhibit Mode switch on the back of the chassis to the 
Manual position. Observe that all fans become operational and the power 
switch LED is a steady green. Switching the Inhibit Mode switch to the 
Default position allows the system controller to control the power supply.

This section contains general installation instructions for installing a 
PXI Express system controller in a NI PXIe-1065 chassis. Refer to your 
PXI Express system controller user manual for specific instructions and 
warnings. To install a system controller, complete the following steps:

1.

Connect the AC power source to the PXI Express chassis before 
installing the system controller. The AC power cord grounds the 
chassis and protects it from electrical damage while you install the 
system controller.

2.

Install the system controller into the system controller slot (slot 1, 
indicated by the red card guides) by first placing the system controller 
PCB into the front of the card guides (top and bottom). Slide the