Справочник Пользователя для National Instruments CFP-2220

© National Instruments Corporation

3.

Press down firmly on the backplane to compress the spring until the 
clip locks in place on the DIN rail.

4.

Connect the PE ground terminal on the backplane to safety ground.

Disconnect power and make sure that no I/O modules are in the backplane before 

removing it from the DIN rail.

The horizontal panel-mount kit has mounting holes on the sides of the 
backplane and is NI part number 778616-01. The vertical panel-mount kit 
has mounting holes on the top and bottom of the backplane and is NI part 
number 778688-01. Complete the following steps to mount the system on 
a flat surface.

1.

Fasten the panel-mount plates to the back of the cFP-BP-x using a 
number 2 Phillips screwdriver and the 8-32 

× 5/16 in. countersink 

screws shipped with the kit. You must use these screws because they 
are the correct depth and thread for the plates and backplane.

Figure 9.  Installing the Horizontal Panel-Mount Kit on the cFP-BP-4