Справочник Пользователя для Raritan Computer II
46
P
ARAGON
II U
SER
M
ANUAL
Connecting Z-CIMs as Tiers
The following diagram shows the final setup when connecting Z-Series Z4200U Z-CIMs as a tier:
Figure 42 Connecting a Z-CIM as a Tier to Paragon II
Important: Z-Series installation requires that each computer be assigned a channel name as it is
added to the Z-CIM chain. Computer channels are organized alphabetically by assigned name (or
the default name, the Z-CIM’s serial number), rather than in the order of their placement within the
Z-CIM chain. We recommend that installers assign channel names before connecting all
computers to eliminate any difficulty in locating the respective channel for each computer.
the default name, the Z-CIM’s serial number), rather than in the order of their placement within the
Z-CIM chain. We recommend that installers assign channel names before connecting all
computers to eliminate any difficulty in locating the respective channel for each computer.
Note: When following the installation and configuration instructions below, sort the Selection Menu by
Channel ID Number, not by Name. Display the menu by pressing [F2] and change the sorting method by
pressing [F12].
Channel ID Number, not by Name. Display the menu by pressing [F2] and change the sorting method by
pressing [F12].
All Paragon II components must be powered ON prior to Z-CIM tier installation. All computers in the Z-
CIM chain and all Z4200U components must be powered OFF prior to installation.
Connect a Z-CIM as a Tier:
1. Connect a Category 5e UTP cable to the channel port on the Paragon II unit reserved for the Z-CIM
CIM chain and all Z4200U components must be powered OFF prior to installation.
Connect a Z-CIM as a Tier:
1. Connect a Category 5e UTP cable to the channel port on the Paragon II unit reserved for the Z-CIM
chain.
2. Connect the other end of this Category 5e UTP cable to the UTP OUT port on a Z-CIM, which will be
the first Z-CIM in the chain.
3. Connect a computer to the first Z-CIM.
For UKVMSPD Z-CIM:
For UKVMSPD Z-CIM:
a. Connect the 6-pin mini-DIN keyboard and mouse and HD15 video connectors on the UKVMSPD
Z-CIM to computer’s keyboard, mouse, and video ports.
b. Place the Z-CIM Terminator in the Z-CIM’s UTP IN port.
c. Power
c. Power
ON
computer.
For UKVMSC Z-CIM with local port:
a. Connect DB25 male end of CCPnn cable to DB25 female port on back of a Z-CIM (UKVMSC).
b. Connect other end to computer’s keyboard, video, and mouse ports.
b. Connect other end to computer’s keyboard, video, and mouse ports.
IN OUT PC
Last Z-CIM
Z-CIM Terminator
Z-CIMs
Z-CIM
Z-CIMs
Up to 42
Cat 5e
Cat 5
e
Ca
e
t
5
Servers
Up to 42
U
K
VM
S
P
D
U
K
V
M
S
P
D
U
K
V
M
S
P
D
C
a
e
t 5
C
a
e
t 5
Back of P2-UMT832