Справочник Пользователя для RAD Data comm IPmux-1
IPmux-1/1E Installation and Operation Manual
Chapter 5 Application Configuration Procedures
IPmux-4 5-11
Configuration
Host IP Address
Frames will not leave the device until IP and Mask addresses are defined.
➤
To configure Host IP Address:
1. From the Main menu, select 2 Configuration.
2. From the Configuration menu select 1 General Configuration (refer to
1. From the Main menu, select 2 Configuration.
2. From the Configuration menu select 1 General Configuration (refer to
Figure 5-2).
3. From the General Configuration menu, press 1.
4. Enter the Host IP Address and Mask.
5. Press <Esc> a few times back to the General Configuration menu.
4. Enter the Host IP Address and Mask.
5. Press <Esc> a few times back to the General Configuration menu.
Remember to press <Enter> after modifying each parameter. Press <S> to save
all changes on the menu.
E1/T1 Configuration
➤
To configure E1/T1:
1. From the Configuration menu select 3 E1/T1 Configuration.
2. The Channel Number Configuration menu appears, press 2 (to choose
1. From the Configuration menu select 3 E1/T1 Configuration.
2. The Channel Number Configuration menu appears, press 2 (to choose
Channel Number 2).
3. The E1/T1 Configuration menu appears, press 1 Physical Layer Configuration
(see Figure 5-6).
4. Select Transmit Clock Source and chose Loopback.
5. Select Channel Type and choose CRC4 Disable.
6. Select Signaling Mode and choose CAS Disable.
7. Press <Save>.
8. Press <Esc> to exit the Physical Layer Configuration menu and return to the
5. Select Channel Type and choose CRC4 Disable.
6. Select Signaling Mode and choose CAS Disable.
7. Press <Save>.
8. Press <Esc> to exit the Physical Layer Configuration menu and return to the
E1/T1 Configuration menu.
Remember to press <Enter> after modifying each parameter. Press <S> to save
all changes on the menu.
Main Menu
↓
2. Configuration
↓
1. General
Configuration
Configuration
↓↓↓↓
1. Host IP
Note
Main Menu
↓
2. Configuration
↓
3. E1/T1
Configuration
Configuration
↓
2. Channel
Number
Configuration
Number
Configuration
↓↓↓↓
1.
Physical
Layer
Configuration
Note
Note
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com