Справочник Пользователя для RAD Data comm ASMi-31

ASMi-31 Installation and Operation Manual

Chapter 2. Installation and Setup

16-05-01 13:37

Installation and Setup

2-7

➤

➤ To connect the line:

1. Insert the screwdriver into a square hole (see Figure 2-3).

Figure 2-3 Connecting the Line – Step 1

2. Raise the inserted screwdriver, putting pressure on the ramp within the

square hole (see Figure 2-4).

Figure 2-4 Connecting the Line – Step 2

3. Insert the stripped end of the wire and remove the screwdriver (see

Figure 2-5).

Figure 2-5 Connecting the Line – Step 3

Connecting the DTE
The rear-panel DTE connector provides interface for data input/output,
clock reference and control signal exchange between ASMi-31 and the DTE.
The DTE interface is changeable module with the interface connector. The
DTE is connected to ASMi-31 via adapter cables depending on the interface
type, see Table 2-2 to select the correct cable for your DTE interface.

Table 2-2 DTE Interfaces and Matching Adapter Cables

DTE Interface

Connector Description

RAD Cable

V.24/RS-232

25-pin, D-type, female

CBL-HBT/V24

V.35

34-pin, female

CBL-HBT/V35

X.21

15-pin, female

CBL-HBT/X21

Order from: Cutter Networks

Ph:727-398-5252/Fax:727-397-9610