Справочник Пользователя для RCA 300 Series
2 SpeedTouch™ Installation
E-SIT-CTC-20030702-0003 v4.0
20
6
The installer copies the necessary files to your computer.
7
The following screen appears:
Click OK to proceed.
8
At the end of the procedure, the following window appears:
Click Restart to finish the installation and restart your computer.
The hardware
installation procedure
After restarting your computer, proceed as follows:
1
Use the ADSL cable provided to wire the SpeedTouch™ ADSL port to your tele-
phone wall outlet or distributed filter.
phone wall outlet or distributed filter.
2
Insert the SpeedTouch™'s USB connector into the computer's USB port.
A USB port can be easily located, it is marked with the typical USB symbol:
A USB port can be easily located, it is marked with the typical USB symbol:
.
Note
You can also connect your SpeedTouch™ to the computer via a USB
hub.
hub.
3
On the Apple menu, point Control Panels and click Modem:
4
The Modem control panel appears
Make sure the SpeedTouch™ is selected in the Connect via list and Modem list.
Note
If you are using an RFC1483 Bridged connection you may only have to
adjust the Modem list selection.
adjust the Modem list selection.