Справочник Пользователя для RCA 300 Series

2 SpeedTouch™ Installation

E-SIT-CTC-20030702-0003 v4.0

2.2.2 Installation for Mac OS X

Supported Operating

Systems

The following OS must be readily installed on your computer:

•

Mac OS X v10.1, v10.2 and v10.3

Mac OS X v10.0 users must download the free upgrade to Mac OS X v10.1 
to be able to install and use the SpeedTouch™ device.

Minimum system

requirements

For Mac OS X v10.1:

•

121 megabytes (MB) of free disk space (during installation process)

For Mac OS X v10.2 and v10.3:

•

21.6 megabytes (MB) of free disk space (during installation process)

The SpeedTouch™

Installation

The SpeedTouch™ installation consists of two major parts:

•

The software installation procedure

•

The hardware installation procedure

If you want to connect to the Internet via a PPP (PPPoA or PPPoE) connection some 
additional configuration is required.

Mac OS X differences

Depending on the Mac OS X version your computer runs, some windows may differ 
from the windows shown in the installation procedures.

The driver installation

procedure

Proceed as follows:

Insert the SpeedTouch™ Setup CD-ROM in your computer's CD-ROM drive and 
open the OSX folder.

Open the Setup folder.

Depending on your Service Provider’s specifications open either the:

•

 folder

to install a PPPoA connection or a PPPoE connection

•

 folder

to install an RFC1483 Bridged connection.

In this folder open the folder corresponding to your local setting (this should be 
specified by your Service Provider) and double-click SpeedTouchUSB.pkg to start 
the installation procedure.

If your computer runs Mac OS X v10.1 or v10.2, the installation wizard 
may prompt you for authentification. If this is the case, click   to 
enter your credentials.

If your computer runs Mac OS X v10.3, your computer will prompt 
you to run a program to determine if the installer package can be 
installed. Click Continue.