Справочник Пользователя для IBM EtherLink XL
2-4
C
HAPTER
2: I
NSTALLING
THE
A
DAPTER
Connecting the Remote Wake-Up Cable
WARNING: Install the adapter in slot 1 in the PC (as
described earlier) before plugging in the 3-pin connector.
Only properly trained and authorized personnel should
perform service. Contact your PC manufacturer for
information about safe service techniques.
described earlier) before plugging in the 3-pin connector.
Only properly trained and authorized personnel should
perform service. Contact your PC manufacturer for
information about safe service techniques.
1 Insert the cable into the connector on the adapter,
Twist the cable twice before attaching the cable to the
motherboard.
motherboard.
2 Attach the cable to the connector on the PC
motherboard, as shown in Figure 2-3.
The connector is located in different locations depending
on the PC.
on the PC.
Figure 2-3 Connecting the Adapter to the Connector
3 Reconnect all cables and replace the PC cover.
The 3C905B-TX Remote Wake-Up adapter is installed. Go
back to the previous section, “Connecting to the Network,”
to complete installation.
back to the previous section, “Connecting to the Network,”
to complete installation.
Plug in Remote Wake-Up
cable to connector here
cable to connector here
Connect Remote Wake-Up
cable from adapter to
motherboard connector
cable from adapter to
motherboard connector
Power
supply
supply