Справочник Пользователя для McDATA 3000
B-13
Maintenance and Diagnostics Connections
attached to the DTE interface on the PC and connect the other end of
the RS-232 cable to the serial interface on the UltraNet Edge 3000. See
Figure B-6.
the RS-232 cable to the serial interface on the UltraNet Edge 3000. See
Figure B-6.
Figure B-6
PC Connection to Serial Interface
RS-232 Serial Interface
The UltraNet Edge 3000 has one serial interface which is used for
console connections. This interface is set to communicate at 38.4K
bps, with eight data bits, 1 stop bit, no parity, and no hardware flow
control.
console connections. This interface is set to communicate at 38.4K
bps, with eight data bits, 1 stop bit, no parity, and no hardware flow
control.
Table B-2 provides the pinouts for the serial interface on the UltraNet
Edge 3000 unit.
Edge 3000 unit.
Sb121
EE
PC
DTE
UltraNet Edge
Table B-2
RS-232 Serial (RJ45) Interface Pinouts
Pin
Signal
1
DSR (Data Set Ready)
2
DCD (Data Carrier Detect)
3
DTR (Data Terminal Ready)
4
GND (Signal Ground)
5
RXD (Receive Data)
6
TXD (Transmit Data)
7
CTS (Clear To Send)
8
RTS (Request To Send)