Справочник Пользователя для 3com SuperStack II
Configuring Serial Ports with DCEs
75
3 Set the baud rate (56 or 64 kbps) for the DS0 channel using:
SETDefault !<path> -PATH T1DSoChnlBaud = <FT156K|FT164K>
4 Set the path clock using:
SETDefault !<path> clock = [Internal | External]
5 Re-enable the path using:
SETDefault !<path> -PATH CONTrol = Enabled
The following optional settings are also available:
■
T1FrameMode
■
Superfame (SF)
■
Extended Superframe (ESF)
■
T1LineCoding
■
Binary with 8 zero substitution (B8ZS)
■
Alternate Mark Inversion (AMI)
■
Alternate Mark Inversion with bit 7 zero code substitution
(AMIB7ZCS)
(AMIB7ZCS)
Configuring Serial
Ports with DCEs
Ports with DCEs
This section describes how to configure the serial ports with modems,
CSU/DSUs, or ISDN TAs attached.
CSU/DSUs, or ISDN TAs attached.
Before beginning this procedure, complete the following tasks:
■
Cable the serial port and connect it to the telephone network.
■
Log on to the system with Network Manager privilege.
The serial port automatically detects the following settings:
■
Line type — dial-up or leased
■
Clock — external
■
Connector type — RS-232, V.35, X.21, RS-449, or RS-530
ISDN TAs
If you are attaching an ISDN TA, you must configure the TA with the
SPIDs, switch type, local telephone numbers, and Multilink PPP options
SPIDs, switch type, local telephone numbers, and Multilink PPP options
LH4 = 22.5 db
SH4 = 399 - 533 feet
SH5 = 533 - 655 feet
SH5 = 533 - 655 feet