Справочник Пользователя для 3com SuperStack II

C

HAPTER

 6: B

ASIC

 C

ONFIGURATION

 

OF

 P

ORTS

 

AND

 P

ATHS

before you connect it to the SuperStack II bridge/router. See the 
documentation that came with your TA for more information.

To configure the serial port with a DCE, follow these steps:

1 The default baud rate for the serial port is 64 Kbps. If you need to change 

the baud rate, use:

SETDefault !<path> -PATH Baud = <kbps> (1.2-2048)

2 The default device type is Modem. Specify the external device type 

attached to the Flex-WAN cable using:

SETDefault !<path> -PATH ExDevType = [Modem | Bri | Sw56]

3 If you have changed any of the default settings, re-enable the path to 

make sure all settings on the path take effect using:

SETDefault !<path> -PATH CONTrol = Enabled

This section describes how to configure the serial ports when connecting 
directly to IBM legacy equipment.

Before beginning this procedure, complete the following tasks:

■

Attach the Flex-WAN cable to the serial port and the DTE.

■

Log on to the system with Network Manager privilege.

The Flex-WAN serial port automatically detects the following settings:

■

Line type — leased

■

Clock — internal

■

Connector type — RS-232, V.35, X.21, or RS-449

To configure the serial port with a DTE, follow these steps:

1 The default baud rate for the serial port is 64 Kbps. If you need to change 

the baud rate, use:

SETDefault !<path> -PATH Baud = <kbps> (1.2-2048)

2 Set the owner of the serial port using:

SETDefault !<port> -PORT OWNer = BSC | ATUN | SHDLC | SDLC

See Using Enterprise OS Software for more information about IBM legacy 
protocols.