Справочник Пользователя для Enterasys Networks X16-C
Attaching Cables, Installing Compact Flash Card and DIMM Upgrade Kit
Matrix X16-C Chassis Installation Guide 3-31
Figure 3-27 Connecting a VT Series Terminal
Connecting the CM COM Port to a Modem
To connect a modem to the CM COM port (
), use a UTP cable with RJ45 connectors and
a user‐supplied RJ45‐to‐DB25 male adapter, and proceed as follows:
1.
Connect the RJ45 connector at one end of the cable to the COM port of the CM.
2.
Plug the RJ45 connector at the other cable end into a user‐supplied, RJ45‐to‐DB25 modem
adapter.
adapter.
3.
Connect the RJ45‐to‐DB25 adapter to the communications port on the modem.
4.
Turn on the modem.
5.
With a PC connected to a remote modem, you can configure the switch remotely. To do so, you
must configure your PC VT emulation package with these parameters.
must configure your PC VT emulation package with these parameters.
6.
Connect the X16‐C’s power cords. Refer to “
1 UTP cable with RJ45 connectors
3 RJ45-to-DB25 VT adapter
2 RJ45 COM port
4 VT series terminal
STATUS
ACTIVE/
STANDBY
RESET
USB
ETHERNET
COM
2
3
4
1
Parameter
Setting
Mode
7 Bit Control
Transmit
Transmit=19,200
Bits Parity
8 Bits, No Parity
Stop Bit
1 Stop Bit