Справочник Пользователя для Enterasys Networks X16-C
Powering Up the Matrix X16-C Chassis
Matrix X16-C Chassis Installation Guide 3-41
Powering Up the Matrix X16-C Chassis
To power up the Matrix X16‐C chassis, proceed as follows:
1.
Plug one end of each power cord (included with the power supply) into the AC power inlet on
the chassis back panel and tighten the cord lock bracket screw, as shown in
the chassis back panel and tighten the cord lock bracket screw, as shown in
Figure 3-35 Connecting 20 Amp AC Power Cord to the Power Supply
2.
Plug the other end of each power cord into a dedicated 20 A/110 Vac or 10 A/220 Vac
receptacle. If you are using the optional twist lock power cord, plug it in and turn until it locks
securely. Refer to
receptacle. If you are using the optional twist lock power cord, plug it in and turn until it locks
securely. Refer to
on page A‐4 for more information.
3.
Repeat steps 1 and 2 for all power cords.
4.
Ensure that the Power LEDs on each power supply are green.
5.
Ensure that all fans in the fan tray unit are operating properly when power is received from
the power supply modules (fan tray LED will be green). For more information on the power
supply LEDs, refer to “
the power supply modules (fan tray LED will be green). For more information on the power
supply LEDs, refer to “
If you experience any problems with this installation, contact Enterasys Networks for assistance.
The Matrix X16‐C is now ready to be configured.
The Matrix X16‐C is now ready to be configured.
1 Power cord
NOTE: Power cords shown are for North America.
2 AC inlet (AC1) and cord lock bracket
Each power unit requires a 20 Amp circuit.
AC INLET 2
100-125V-20A
200-240V-8A
50/60Hz
AC INLET 1
100-125V-20A
200-240V-8A
50/60Hz
1
2