Справочник Пользователя для Dynalink RTA1046VW

Before You Use

xiii

Remote management accesses control

Telnet/SSH session for local or remote management

Firmware upgrades through HTTP, TFTP, or FTP

The boot loader contains very simple web page to allow the users to update
the run-time firmware image.

Configuration file backup and restore

SNMPv1/v2 agent with MIB-II, ADSL Line MIB

Subscription for ADSL Service

To use the IAD, you have to subscribe for ADSL service from your broadband
service provider. According to the service type you subscribe, you will get various IP
addresses:

Dynamic IP:

If you apply for dial-up connection, you will be given an Internet

account with username and password. You will get a dynamic IP by dialing up to
your ISP, such as using PPPoA, PPPoE, or MER mode.

Static IP address:

If you apply for full-time connectivity, you may get either one

static IP address or a range of IP addresses from your ISP. The IP address varies
according to different ADSL service provider, such as using IPoA or MER mode.

Notes and Cautions

Note and Caution in this manual are highlighted with graphics as below to indicate
important information.

Note

Contains information that corresponds to a specific topic.

Caution

Represents essential steps, actions, or messages that should not be
ignored.