Справочник Пользователя для Dynalink RTA1046VW

Chapter 1: Overview   

                                                                                                                                                                                       

This chapter provides you the description for the LEDs and connectors on the front 
and rear surface of the IAD. Before you use/install this wireless IAD, please take a 
look at the information first. 

Physical Outlook 

The following illustration displays the front panel of the Wireless IAD: 

 

The Wireless IAD is equipped with several LEDs on the front panel as described in 
the table below: 

Off 

Power is off. 

Solid Green 

Power is on and the device operates normally. 
Power on self-test in progress 
The device enters the console mode of the boot 
loader. 

Solid Red 

Power on self-test failure if the led always stays solid 
red. 

Flash Red 

Firmware upgrades in progress 

Off 

No DSL signal is detected. 

Slow Flash Green 

DSL line is handshaking in progress 

Fast Flash Green 

DSL line is training in progress 

Solid Green 

DSL line connection is up. 

Off 

No PPPoA or PPPoE connection 

Solid Green 

At least one PPPoA or PPPoE connection is up. The 
users can access the Internet now. 

Off 

No Ethernet signal is detected. 

Flash Green 

User data is going through Ethernet port 

Solid Green 

Ethernet interface is ready to work. 

Off 

No USB signal is detected. 

Flash Green 

User data is going through USB port 

Solid Green 

USB interface is ready to work. 

Off 

No radio signal is detected. 

Flash Green 

User data is going through WLAN port 

Solid Green 

WLAN interface is ready to work. 

Off 

The phone is on-hook or in PSTN mode. 

Flash Green 

There is one incoming VoIP phone call. 

Solid Green 

VoIP phone call is in use. 

Off 

Voice over IP service is not ready. The users can 
make PSTN phone calls only. 

Solid Green 

Voice over IP service is ready.