Справочник Пользователя для Dynalink RTA1046VW

Chapter 2: System Requirement and Installation 

 

System Requirement 

To access the Wireless IAD via Ethernet, the host computer must meet the following 
requirements: 

™ 

Equipped with an Ethernet network interface. 

™ 

Have TCP/IP installed. 

™ 

Allow the client PC to obtain an IP address automatically or set 
a fixed IP address.   

™ 

With a web browser installed: Internet Explorer 5.x or later. 

The Wireless IAD is configured with the default IP address of 192.168.1.1 and 
subnet mask of 255.255.255.0. Considering that the DHCP server is enabled by 
default, the DHCP clients should be able to access the Wireless IAD, or the host PC 
should be assigned an IP address first for initial configuration.   

You also can manage the Wireless IAD through a web browser-based manager: 
ADSL ROUTER CONTROL PANEL. The Wireless IAD manager uses the HTTP 
protocol via a web browser to allow you to set up and manage the device.   

   

 

To configure the device via web browser, at least one 
properly-configured PC must be connected to the network (either 
connected directly or through an external hub/switch to the LAN port of 
the device). 

 

Choosing a place for the Wireless IAD 

n

 

Place the Wireless IAD close to ADSL wall outlet and power outlet for the 
cable to reach it easily.   

o

 

Avoid placing the device in places where people may walk on the cables. Also 
keep it away from direct sunlight or heat sources. 

p

 

Place the device on a flat and stable stand.