Справочник Пользователя для Dynalink RTA1046VW

Chapter 4: Web Configuration 

                                                                                                                                                                                       

To set WAN settings for each service, please open Advanced – Internet. This page 
allows you to edit, to remove, or to add WAN settings. 

If you click the Connect hyperlink 
under the PVC Name item, the system 
will connect to WAN automatically. If 
the WAN connection is OK, you can 
check the detailed information directly.

You can add new PVC(s) by clicking 
the Add button, edit the settings for 

the present PVC by clicking

 in the 

Edit column, or delete the existing 
PVC by pressing

icon.  

To add a new WAN connection, please click the Add button. The following screen 
appears. 

VPI (Virtual Path Identifier):  
Identifies the virtual path between 
endpoints in an ATM network. The 
valid range is from 0 to 255. Please 
refer to the value that your ISP 
provides. 

VCI (Virtual Channel Identifier):  
Identifies the virtual channel endpoints 
in an ATM network. The valid range is 
from 32 to 65535 (1 to 31 is reserved 
for well-known protocols). Please refer 
to the value that your ISP provides. 

 

Service Category:  
It decides the size and rate for the 
packets of the data in different service 
type. There are five categories 
provided here for your selection, 
shown as the drop-down menu in the 
right column.   

If you select UBR with PCR or CBR, 
you have to offer the value for the 
peak cell rate. 

If you choose Non Realtime VBR, or 
Realtime VBR, you have to key in the 
value for the peak cell rate, 
sustainable cell rate, and maximum 
burst size.   

As you can see in the right figure, the 
range for Peak Cell Rate is from 1 to 
2500; the value for Sustainable Cell 
Rate ranges from 1 to 2499 and must 
be smaller than Peak Cell Rate, and 
the range for Maximum Burst Size is 
from 1 to 1000000.