Справочник Пользователя для Dynalink RTA1046VW

Chapter 4: Web Configuration 

                                                                                                                                                                                       

The WAN IP settings page will differ 
slightly according to the protocol that 
you choose. The graphic is the one 
that you will see if you choose the 
PPPoE mode in the previous step. 
You can select Enable NAT or change 
the MTU value according to your 
needs. 

Add Default Route:   
Check this item to add a default route.

The next figure following the WAN IP 
Settings in the PPPoE mode is shown 
at the right. You may refer to the 
Quick Setup for further information. 

If you choose IP over ATM from the 
Connection Type web page, you will 
get a web page as the figure. 

You may refer to Quick Start – 
Connection Type – IPoA section for 
more information. 

Add Default Route:   
Check this item to add a default IPoA 
route.   

For example, after rebooting your 
wireless IAD, the default route will be 
shown on the Routing Table under 
Status menu, you may check it.   

 

If you choose Bridging from the 
Connection Type web page, you will 
get a web page as the figure listed at 
the right side. 

Please refer to Quick Setup for more 
information. 

After configuring the WAN IP Setting 
page, press Next, and then you will 
see the Summary page. 

Check the information displayed here.

Enable this Internet Connection: 
Check the box to enable this internet 
connection or uncheck it to disable 
this setting. You may change this 

setting by press the Modify icon

on 

the Advanced – Internet Connection 
Configuration page and click Next until 
the summary page is displayed.