Справочник Пользователя для Enterasys Networks E1 Series
Port Configuration Command Set
Disabling / Enabling Ports
4-12
4.3.2
Disabling / Enabling Ports
Purpose
To disable and re-enable one or more ports. By default, all ports are enabled at device startup. You
may need to disable ports in the event of network problems or to put ports “off-line” during certain
configuration procedures.
may need to disable ports in the event of network problems or to put ports “off-line” during certain
configuration procedures.
Commands
The commands needed to enable and disable ports are listed below and described in the associated
section as shown.
section as shown.
•
•
set port enable (
)
4.3.2.1
set port disable
Use this command to administratively disable one or more ports.
set port disable port-string
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable Fast Ethernet front panel port 1:
port-string
Specifies the port(s) to disable. For a detailed description
of possible port-string values, refer to
of possible port-string values, refer to
.
Matrix>set port disable fe.0.1