Справочник Пользователя для Enterasys Networks E1 Series

To disable and re-enable the Link Aggregation Control Protocol (LACP), to display and configure 
LACP settings for one or more aggregator ports, and to display and configure the LACP settings for 
underlying physical ports that are potential members of a link aggregation.

The commands used to review and configure LACP are listed below and described in the associated 
section as shown.

set lacp (

)

set lacp static (

clear lacp static (

set port lacp (

)

Use this command to disable or enable the Link Aggregation Control Protocol (LACP) on the 
device.

set lacp {disable | enable}

None.

Switch command.

NOTE: Commands with the keyword lacp can only be used when the device is in 
802.3ad mode. This mode can be reset using the set trunkmode command as 
described in 

disable | enable

Disables or enables LACP.