Справочник Пользователя для Enterasys Networks E1 Series
VLAN Configuration Command Set
Creating and Naming Static VLANs
7-9
7.3.2
Creating and Naming Static VLANs
Purpose
To create a new static VLAN, or enable/disable the new or other existing static VLANs.
Commands
The commands needed to establish new or remove VLANs are listed below and described in the
associated section as shown.
associated section as shown.
•
set vlan (
•
set vlan name (
)
•
clear vlan (
)
•
clear vlan name (
)
7.3.2.1
set vlan
Use this command to create a new static IEEE 802.1Q VLAN, or to enable or disable an existing
VLAN. When a new VLAN is created, it is added to the list of VLANs that the device will
recognize. Once a VLAN is created, you can assign it a name using the set vlan name command
described in
VLAN. When a new VLAN is created, it is added to the list of VLANs that the device will
recognize. Once a VLAN is created, you can assign it a name using the set vlan name command
described in
.
set vlan {create | enable | disable} vlan-list
Syntax Description
Command Defaults
None.
NOTE: Each VLAN ID must be unique. If a duplicate VLAN ID is entered, the device
assumes that the Administrator intends to modify the existing VLAN.
assumes that the Administrator intends to modify the existing VLAN.
Enter the VLAN ID using a unique number between 2 and 4094. The VLAN IDs of 0, 1,
and 4095 and higher may not be used for user-defined VLANs.
and 4095 and higher may not be used for user-defined VLANs.
create | enable |
disable
disable
Creates, enables or disables a VLAN.
vlan-list
Specifies the number of the VLAN(s) to be created, enabled
or disabled.
or disabled.