Справочник Пользователя для Enterasys Networks E1 Series
Process Overview: Routing Protocol Configuration
Configuring RIP
13-2
13.1.1 Configuring RIP
Purpose
To enable and configure the Routing Information Protocol (RIP).
RIP Configuration Task List and Commands
lists the tasks and commands associated with RIP configuration. Commands are
described in the associated section as shown.
NOTE: Enabling RIP with the router rip and network commands is required if you
want to run RIP on the device. All other tasks are optional.
want to run RIP on the device. All other tasks are optional.
Table 13-1
RIP Configuration Task List and Commands
To do this...
Use these commands...
Enable RIP configuration mode and
associate a network.
associate a network.
router rip (
)
network (RIP) (
)
Allow unicast updates by defining a
neighboring router.
neighboring router.
neighbor (RIP) (
)
Configure an administrative distance.
distance (
)
Apply offsets to RIP routing metrics.
ip rip offset (
Adjust timers.
timers (
)
Specify a RIP version.
ip rip send version (
ip rip receive version (