Справочник Пользователя для Enterasys Networks E1 Series
Security Configuration Command Set
Configuring RADIUS
14-8
Examples
This example shows how to enable the RADIUS client for authenticating with a RADIUS server 1
at IP address 10.1.6.203, UDP authentication port 1812. As previously noted, the “server secret”
password entered here must match that already configured as the Read-Write (rw) password on the
RADIUS server:
at IP address 10.1.6.203, UDP authentication port 1812. As previously noted, the “server secret”
password entered here must match that already configured as the Read-Write (rw) password on the
RADIUS server:
This example shows how to set the RADIUS timeout to 5 seconds:
This example shows how to set RADIUS retries to 10:
14.3.1.3 clear radius
Use this command to reset RADIUS server settings to default values.
clear radius {[last-resort-action [local | remote]] [retries] [server {index | all}]
[timeout]}
[timeout]}
Syntax Description
Command Type
Switch command.
Matrix>set radius server 1 10.1.6.203 1812
Server Secret:******
Retype Server Secret:******
Warning: rfc2138 recommends secret minimum length of 16
Matrix>set radius timeout 5
Matrix>set radius retries 10
last-resort-action
local | remote
local | remote
Resets the last resort local and/or remote action to
Challenge.
Challenge.
retries
Resets the maximum number of attempts a user can contact
the RADIUS server before timing out to 3.
the RADIUS server before timing out to 3.
server index | all
Resets a specific or all RADIUS server configurations.
timeout
Resets the maximum amount of time to establish contact
with the RADIUS server before timing out to 20 seconds.
with the RADIUS server before timing out to 20 seconds.