Справочник Пользователя для Dynalink RTA1025W
ADSL Router User Manual
132
Problems with Upgrading
The following lists the error messages that you may see during upgrading and the
action to take.
action to take.
Error message: All the ADSL LEDs light up and cannot light off as usual.
Possible cause: When users are executing firmware upgrade and saving
settings to the router, the power for the router is lost for some unknown reasons,
the normal web page for the router might be damaged. After power on your
router, the LEDs might not work normally.
settings to the router, the power for the router is lost for some unknown reasons,
the normal web page for the router might be damaged. After power on your
router, the LEDs might not work normally.
Action: Setup you PC with a static IP address, such as 192.168.1.2, and then
access the router’s web page by entering
access the router’s web page by entering
. Then update the
firmware again.
Error Message: Image uploading failed. The selected file contains an illegal
image.
image.
Possible cause: The firmware file format is invalid.
Action: Check to see whether the file format is correct; otherwise download a
firmware file with correct format.
firmware file with correct format.
Error Message: Image uploading failed. The system is out of memory.
Possible cause: It may be caused by the lack of memory.
Action: Reboot your ADSL Router and perform the upgrade task again.
Error Message: Image uploading failed. No image file was selected.
Possible cause: You did not select a file correctly.
Action: Download a compatible firmware from the web.