Справочник Пользователя для Fortinet Version 3.0

config system admin

edit <admin_name_str>

set password <password>

set accprofile prof_admin

end

For example:

config system admin

edit new_admin

set password p8ssw0rd

set accprofile prof_admin

end

For more information about configuring administrators see 

.

Use the following procedure to reset the FortiBridge unit to the factory default 
configuration. You might want to rest the FortiBridge to the factory default 
condition if the FortiBridge unit is not functioning as expected and you would like 
to re-start the configuration process. Resetting to the factory default configuration 
resets all configuration changes that you have made, including the management 
IP address. See 

Press and release the Factory reset button.

Use a pen or other pointed object to press the button.

After a few seconds the FortiBridge unit restarts; reset to the factory default 
configuration. You can now re-configure the FortiBridge unit.

Log into the CLI.

Enter the following command:

execute factoryreset

Type y and press Enter.

After a few seconds the FortiBridge unit restarts; reset to the factory default 
configuration. You can now re-configure the FortiBridge unit.

Select a procedure from 

Table 8

 to install FortiBridge unit firmware.

Before beginning any of the procedures in this section, you must have the 
FortiBridge firmware image file that you are going to install on the FortiBridge unit. 
During these procedures you are required to enter the name of the firmware 
image file.