Справочник Пользователя для Avaya X330WAN

Chapter 3

Initial Configuration

20

Avaya X330WAN User’s Guide

All CLI commands mentioned in this section are described in Chapter 6: X330WAN 
CLI Commands.
To configure Loopback interfaces:
1

Enter the Interface Loopback mode using the 

 

[<interface number>[.ip-interface]]

 command. 

 typing 

 enters a context for configuring 

the Loopback1 interface parameters.
The prompt changes to 

X330WAN-2DS1-N(super-if:Loopbackn)#

where 

N

 is the switch number and 

n

 is the Loopback interface number.

2

Use  the 

 <ip address> <mask>

 command to assign an IP address 

and subnet mask to the interface.

3

Type 

 to return to Supervisor mode. 

The prompt returns to 

X330WAN-2DS1-N(super)#

The first IP interface created in the X330WAN automatically becomes the PMI 

(Primary Management Interface), described in detail on page 34. It is recommended 
to configure the Loopback interface as the first Layer 2 interface and to configure an 
IP interface on it. After the PMI is configured, the following message appears:

The primary management interface has changed.

For this change to take effect, you need to copy running-config 

startup-config and then reset the device.

Enter the 

 and 

 

commands at this 

stage.

All CLI commands mentioned in this section are described in Chapter 6: X330WAN 
CLI Commands.
To configure Fast Ethernet interfaces:
1

Type 

 to enter the Interface Configuration mode.

The prompt changes to 

X330WAN-2DS1-N(super-if:FastEthernet1)#

2

Use  the 

 <ip address> <mask>

 command to assign an IP address 

and subnet mask to the interface.

3

Type 

 to return to Supervisor mode.

The prompt returns to 

X330WAN-2DS1-N(super)#

The first IP interface created in the X330WAN automatically becomes the 

PMI, described in detail on page 34. It is recommended to configure the Loopback 
interface as the first Layer 2 interface and to configure an IP interface on it. After the