Справочник Пользователя для Avaya X330WAN

Configuring the X330WAN

Avaya X330WAN User’s Guide

21

PMI is configured, the following message appears:

The primary management interface has changed.

For this change to take effect, you need to copy running-config 

startup-config and then reset the device.

Enter the 

 and 

 

commands at this 

stage.

All CLI commands mentioned in this section are described in Chapter 6: X330WAN 
CLI Commands.
To configure a FabricFast Ethernet interface:
1

Use  the

<if-number>

 command to enter the 

FabricFast Ethernet interface context, where the if-number format is 

port[:vlan[.ip-interface index]]

.

You do not need to include the ip-interface index if you configure only one IP 

interface.

2

Use  the

 command to assign an IP address to the interface.

 To configure the IP addresses 10.10.10.1 on VLAN 2 and 20.20.20.1 

and 30.30.30.1 on VLAN 3 perform the following:

X330WAN-2USP-1(super)# interface FabricFastEthernet 1:2

X330WAN-2USP-1(super-if:FabricFastEthernet1:2)# ip address 

X330WAN-2USP-1(super-if:FabricFastEthernet1:2)# exit

X330WAN-2USP-1(super)# interface FabricFastEthernet 1:3.1

X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.1)# ip address 

X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.1)# exit

X330WAN-2USP-1(super)# interface FabricFastEthernet 1:3.2

X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.2)# ip address 

X330WAN-2USP-1(super-subif:FabricFastEthernet1:3.2)# exit

The first IP interface created in the X330WAN automatically becomes the 

PMI, described in detail on page 34. It is recommended to configure the Loopback 
interface as the first Layer 2 interface and to configure an IP interface on it. After the 
PMI is configured, the following message appears: