Справочник Пользователя для Foundry Networks FGS624XGP
FastIron GS Compact Layer 2 Switch Hardware Installation Guide
7 - 12
© 2007 Foundry Networks, Inc.
September 2007
•
Gently lift the cover off of the chassis as shown in Figure 7.6.
Figure 7.6
Removing the Top Cover
5.
Proceed to “Installing a POE Daughter Card” .
Installing a POE Daughter Card
To replace or install the POE daughter card, do the following:
1.
Disassemble the FGS chassis as instructed in the section “Disassembling the Chassis” on page 7-11.
2.
If you are replacing the POE daughter card, remove the existing card from the connector slot on the main
board. Figure 7.8 and Figure 7.9 show the locations of the POE daughter cards on the main board of the
FGS624P-POE and the FGS648P-POE.
board. Figure 7.8 and Figure 7.9 show the locations of the POE daughter cards on the main board of the
FGS624P-POE and the FGS648P-POE.
3.
Install the new POE daughter card:
•
Remove the POE daughter card from its packaging. The POE daughter card is keyed to prevent
improper insertion, as shown in Figure 7.7.
improper insertion, as shown in Figure 7.7.
Figure 7.7
POE Daughter Card
•
Locate the connector slots for the POE daughter card on the main board (Figure 7.8 and Figure 7.9).
FGS-2X
G