Справочник Пользователя для Foundry Networks FGS624XGP
FastIron GS Compact Layer 2 Switch Hardware Installation Guide
7 - 14
© 2007 Foundry Networks, Inc.
September 2007
Figure 7.9 shows the location of the POE daughter cards on the main board of the FGS648P-POE.
Figure 7.9
Installing a POE Daughter Card in the FGS648P-POE
4.
Re-assemble the device as instructed in the section “Re-assembling the Chassis” .
5.
Power ON the chassis and observe the console. The following message will appear:
Info: PoE module detected in slot 1. Initializing....
6.
Enable POE and configure POE parameters. See the Foundry FastIron Configuration Guide for information.
Re-assembling the Chassis
This section provides instructions for re-assembling the FGS device after removing, installing, or replacing a 10-
GbE module.
GbE module.
1.
Replace the device’s cover by gently guiding the cover into place.
2.
Once the cover is properly positioned, re-fasten the screws on each side of the cover.
3.
If the device is rack-mounted, replace the mounting brackets.
POE Daughter Cards