Справочник Пользователя для Citizen Systems CT-S300

— 28 —

5.

Returning to the memory switch select mode

When the setting of the desired content is completed, open the paper cover
and then close the paper cover.  This allows the printer to print the setting
of the changed memory switch.

6.

Saving the setting and exiting the memory switch setting mode

Press the FEED switch short to move to “Write/Factory Setting”.  Then
press and hold the FEED switch.  The printer prints the content of new
setting and exits the memory switch setting mode to return to the normal
standby state.
* Unless saving the setting is executed, the changed setting cannot be

enabled.

7.

Initializing the memory switch

When you want to return the memory switch setting to the initial state, go
to “Write/Factory Setting” in the above procedure.  Here, open the paper
cover and press and hold the FEED switch till buzzer sounds.  This allows
the printer to return to the initial state.
* All the memory switches settings are returned to the factory set values.

4

4

4

6

ø

12

65~75 

µ

m

ø

18

Paper width 80

+0
−1

Maximum print area 72

Maximum print area 48

φ

83 or less

Printing surface

Unit: mm

Use the print paper shown in the following table or the paper with equivalent
quality.

Recommended thermal TF50KS-E2D from Nippon Paper
paper roll

KF50-HAD, PD150R, PD160R from Ohji Paper
F220VP, HP220A, F230AA from Mitsubishi Paper

Paper width 58

+0

−1

Use the paper with the start of winding to roll core is as shown below.
● No fold line is present and paper is along the inner diameter.

● No turnup is present.

● No pasting to core is present.

● Outer winding (print side out) is used.