Справочник Пользователя для FARGO electronic C16
RESTRICTED USE ONLY
Fargo Electronics, Inc.
Persona C16 Card Printer Service Manual (Rev. 5.0)
37
Resolving the Skipping Ribbon Panel issues (continued)
Step Procedure
2
Test the Encoder Sensor.
a. Remove the back cover.
b. Using a Digital Voltmeter, connect the negative lead to ground.
c. Connect the positive lead to Pin 4 of J13.
•
If blocked, the voltage should read 4.9 to 5.5 volts DC.
•
If unblocked, the Sensor should read 0.15 to 0.18 volts DC.
d. If the voltages are not correct, replace the Sensor. See the
procedure in Section 5, page