Справочник Пользователя для Epson TM-P60

This printer is able to be adjusted for the items below:

❏ DIP switch (handshake of serial communication conditions)

❏ Memory switch (serial communication conditions, roll paper width,

                               print density, etc...)

❏ Roll paper width  (58mm / 60mm)

                        Adjusting the spacer and memory switch

The current settings can be confirmed by a self test. (See “3.5.1 Self test mode” (page 3-3).)

When you adjust these items, we recommend you to confirm the new setting. You can confirm the settings  
by running a self-test. See “3.5.1 Self test mode” (page 3-3) for detail. 

You can use a self-test to confirm the current settings. See “3.5.1 Self test mode” (page 3-3).

This printer has DIP switches 1~4. These are located as shown in the figure below.

1. Make sure the printer is turned off.

2. To access the DIP switches, remove the DIP switch cover by hand (pull out the cover and 

then pull it upward to release the projection.)

DIP switch cover

DIP switch

 

projection